What does heating and cooling cost in Traralgon?
2026 guide price ranges for split systems, ducted reverse cycle, gas ducted heating, servicing and repairs, plus what changes a Traralgon heating quote.
A single split system for one room usually costs in the low thousands installed, a ducted reverse cycle system for a whole house costs several times more, and a service or minor repair runs to a few hundred. The ranges on this page are Melbourne metro guide figures, GST included, published in October 2026. A Traralgon quote can come in above or below them, so use them to judge whether a written quote is in a sensible range for the job.
What are the guide price ranges for each heating and cooling job?
Every range below comes from the What’s The Damage? air conditioning cost guide for Melbourne, which states that its prices were verified in October 2026, include GST, are based on the Melbourne metro area and may vary in outer areas. None of them is a Latrobe Valley quote.
| Job | Melbourne guide range | What the range usually covers |
|---|---|---|
| Split system, 2.5 kW, supplied and installed | $1,250 to $2,625 | One small bedroom or study, wall unit inside, outdoor unit on a short pipe run |
| Split system, 5 kW, supplied and installed | $1,900 to $3,675 | A typical lounge or family room |
| Split system changeover, like for like | $1,575 to $3,150 | Taking out an old split and fitting a new one in the same spot, removal included |
| Multi-split with two indoor heads | $4,200 to $7,900 | One outdoor unit running two rooms |
| Ducted reverse cycle, basic | $8,400 to $14,700 | Whole-house heating and cooling through ceiling outlets, minimal zoning |
| Ducted reverse cycle, premium or zoned | $12,600 to $23,100 | Larger homes, more outlets, separate zones you control from a wall panel or app |
| Gas ducted heating, supplied and installed | $4,000 to $11,550 | A gas furnace with ducts and floor or ceiling outlets, heating only |
| Ductwork replacement, whole house | $2,000 to $6,300 | New ducts and outlets on an existing ducted system |
| Air conditioner service and clean | $105 to $335 per unit | One wall split cleaned and checked |
| Ducted system service | $210 to $580 per system | One ducted system checked and cleaned |
| Air conditioner minor repair | $160 to $525 | A sensor, drain, fan or board fault fixed on a call-out |
| Air conditioner major repair or regas | $315 to $1,250 | Leak finding, refrigerant work or a larger part replaced |
For a second opinion on the general level, SolarQuotes published national installed ranges in January 2026 for ducted reverse cycle, multi-head and single split systems. Its figures sit in the same broad territory as the Melbourne table, which suggests the bands are a fair starting point.
The service pages go deeper on each job: split system installation, ducted reverse cycle air conditioning, gas ducted heating and air conditioner servicing. If you already know the system you want, you can ask for a price on that system and compare it with the matching row above.
Why can a Traralgon quote differ from a Melbourne range?
A guide range is an average across many city jobs. A real quote is one business pricing one house, and several things push a valley job one way or the other:
- Travel. A business based in Traralgon prices a job in Traralgon East differently from one in Rosedale or Glengarry. A Melbourne business sending a van down the Princes Freeway will build the drive into its price.
- Climate and sizing. Traralgon nights run about 2 degrees colder than Melbourne’s, and Bureau of Meteorology averages for Latrobe Valley Airport put the July mean minimum at 3.7 C. A system sized properly for heating here may need more capacity than the same room in the city, and capacity costs money.
- The house itself. Much of Traralgon’s growth came with the State Electricity Commission after the Second World War, so the town has a wide mix of older weatherboard and brick homes alongside newer estates. Each has its own roof space, wiring and access, and those details shape the price.
- Workload. Prices and lead times can move when many people want the same work at once, such as the first cold weeks of winter or a run of hot days in January.
What moves the price on a heating or cooling job?
These are the items that most often separate a quote at the bottom of a range from one at the top.
| Price driver | Why it matters |
|---|---|
| System size in kW | Larger units cost more to buy and can need heavier cable and a bigger outdoor unit |
| Number of zones or indoor heads | Each zone or head adds equipment, ducting or piping, and labour |
| Single or double storey | Two storeys mean longer pipe and cable runs, harder access and sometimes two systems |
| Roof space and access | A low, tight roof space or a fragile old tile roof slows ducting work |
| Pipe run length | The further apart the indoor and outdoor units, the more copper pipe, insulation and time |
| Electrical work | SolarQuotes notes some installs need new cables or a new circuit breaker; an old switchboard may need more |
| Removing the old unit | Taking out an old split, a gas wall furnace or a ducted gas heater adds labour and disposal |
| Outdoor unit mounting | A wall bracket can cost less than a ground slab, but SolarQuotes points out it can be noisier |
| Travel and access | Distance from the business’s base, steep blocks and tight side paths |
What should a heating or cooling quote include?
Energy Victoria’s reverse cycle air conditioner buyers guide lists what a quote should show. Use it as your checklist when quotes arrive:
- The recommended system and its heating and cooling capacity.
- Outdoor noise information for the outdoor unit.
- The energy efficiency of the system.
- Installation costs and what the installation includes.
- Any Victorian Energy Upgrades discount.
- Warranty and servicing arrangements.
- Any additional costs.
The same guide says to check the contract sets out the work, the total cost and the timeframe before anything starts. For a replacement job, also look for a line covering removal of the old unit, and for ducted work, a note on whether existing ducts are being reused or replaced.
How does a Victorian Energy Upgrades discount show on a quote?
When an accredited provider, or an installer working with one, applies a Victorian Energy Upgrades discount, the quote shows a lower price for an approved reverse cycle system, so there is no rebate to claim afterwards. It has to be arranged before the work starts. The VEU heating and cooling discounts guide explains eligibility and the steps.
Why is there no price band for gas heater servicing?
Energy Safe Victoria says the cost of a gas heater service will vary depending on the type of appliance, the gasfitter, where the appliance is and other factors, and suggests contacting a few gasfitters for a range of prices (Energy Safe Victoria open-flued heater FAQs). With no published guide to rely on, this site shows no band for it. The gas heater servicing page covers what that service involves.
How do I compare two heating and cooling quotes fairly?
- Line up the capacity. A 5 kW quote and a 7 kW quote for the same room are different jobs, so ask each business why it chose that size.
- Check both quotes cover the same scope: removal of the old unit, electrical work, mounting, the pipe run and any making good.
- Compare warranty and servicing terms as well as the total price.
- Check who holds which licence. Refrigerant work needs an Australian Refrigeration Council licence, gas work needs a gasfitter registered with the Building and Plumbing Commission, and wiring the system into the switchboard is electrical work. Licence lookups for all three trades are set out on the about page.
- If one quote includes a Victorian Energy Upgrades discount and the other does not, ask the second business whether it works with an accredited provider.
What are the red flags on a heating and cooling quote?
- No site visit for a ducted or multi-room system. Energy Victoria advises that the installer should visit to work out the right size, and cautions that oversizing pushes up energy use.
- No heating or cooling capacity written on the quote.
- A single lump sum with no breakdown of what is included.
- Pressure to buy a unit before a Victorian Energy Upgrades discount is confirmed, since retrospective discounts are typically not possible.
- Reluctance to give the names and licence details of the people who will do the refrigerant, gas and electrical work.
How does an enquiry through this site work?
The businesses that receive enquiries are independent local installers and service technicians, and each one inspects the house and writes its own quote. This site passes on your details and does not set or check their prices.
Next step: what to send for quotes you can compare
To get quotes that line up with the table above, send a heating and cooling price enquiry with your suburb, the type of system you want priced, the rooms involved and their rough sizes, whether the house is single or double storey, what the roof is made of, where an outdoor unit could sit, and the make and age of any heater or air conditioner being replaced. Photos of the existing unit and your switchboard help a business price the electrical side without guessing.
Frequently asked questions
- Are the prices on this page Traralgon quotes?
No. They are published Melbourne metro guide ranges from October 2026, including GST. They help you judge whether a quote is in a reasonable range. The price you pay is whatever the business that inspects your house puts in writing.
- Is a cheaper split system always the better buy?
Not always. A unit that is too small for the room runs flat out on a cold valley night and may never warm the space, while one that is far too large can cost more to run. Ask each business to explain the capacity it chose for the room before you compare prices.
- Does removing my old heater or air conditioner cost extra?
Often it does, unless the quote says removal is included. The like-for-like changeover band in the table includes taking out the old split. For a gas heater, ask who disconnects and caps the gas supply and whether disposal is part of the price.
- Why do ducted reverse cycle prices vary so much?
The size of the house, the number of outlets and zones, the roof space, the length of duct runs, the electrical work and whether an old system comes out all change the labour and materials. A zoned system for a large two-storey home sits at the top of the range, a simple system in a small single-storey home near the bottom.
- Can I get a price over the phone or by email?
A business may give a rough figure from photos and room sizes for a simple split system. For ducted or multi-room work, Energy Victoria advises that the installer visits to size the system, so expect a site visit before a firm quote.